Dell PowerConnect W-AirWave 7.6 Guía de inicio rápido descargar pdf (Pagina 10)

8 | Overview Dell PowerConnect W-AirWave 7.6 | Getting Started Guide

f. Select Add when you are finished, and repeat these steps to add additional credentials on which to enable

device scanning.

3. Define a scan set.

a. Navigate to the Device Setup > Discover page and select the Add New Scan Set button.

b. Select the Network(s) to be scanned and the Credential(s) to be used. AirWave defines a unique scan for each

Network/Credential combination.

c. In the Automatic Authorization section, select whether to override the global setting in AMP Setup >

General and have New Devices be automatically authorized into the New Device List, the same

Group/Folder as the discovering devices, the same Group/Folder as the closest IP neighbor, or a specified

auto-authorization group and folder. Be sure to note this location.

d. Select Add when you are finished, and repeat these steps for each scan set that you want to create.

NOTE: Di scovered devices use the default credentials configured on the Device Setup > Communication page for each

vendor-specific device. Refer to "How do I define credentials for devices that communicate with AirWave?" on page

9 for more information.

4. Running a scan set.

a. Navigate to the Device Setup > Discover page and select the check boxes for each scan that you want to

execute.

b. Click the Scan button located below the list of scan sets.

c. View the Start and Stop columns to see the status of the scan. Refresh the browser until both the Start and

Stop columns display date and time information. Newly discovered devices will display on the APs/Devices >

New page. These devices can then be added to your network.

Add Newly Discovered Devices to a Group

Perform the following steps to add a newly discovered device to a group.

1. Select the New Devices link in the header (top of the page). This opens the location where all newly discovered

devices are displayed. This is normally APs/Devices >New, though you may have specified a different location

while defining a scan set.

The information on this page includes the related controller (when known/applicable), the device type (including

vendor and model), the LAN MAC Address, the IP address, and the date/time of discovery. Refer to the following

image.

Figure 4: APs/Devices > New page

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Sin comentarios

Dell PowerConnect W-AirWave 7.6 Guía de inicio rápido Pagina 10