Dell PowerConnect W-AirWave 7.6 Guía de inicio rápido descargar pdf (Pagina 12)

10 | Overview Dell PowerConnect W-AirWave 7.6 | Getting Started Guide

2. Specify SNMP Settings.

a. Specify an SNMPTimeout value. This is the number of seconds that AirWave will wait for a response from a

device after sending an SNMP request, so a smaller number is more ideal.

b. Enter a value for SNMPRetries. This value represents the number of times AirWave attempts to poll a device

when it does not receive a response within the SNMP Timeout period or the Group's Missed SNMP Poll

Threshold setting. As a best practice, we recommend a value of 10.

3. Configure SNMPv3 Informs.

a. Locate the SNMPv3 Informs section and select the Add button to configure all SNMPv3 users that are

configured on the controller. The SNMP Inform receiver in AirWave will restart when users are changed or

added to the controller.

4. Specify Telnet/SSH, HTTP Discovery, and ICMP settings.

a. Specify the Telnet/SSH Timeout value. This value represents the number of seconds used when performing

Telnet and SSH commands.

b. Specify the HTTP Timeout value. This value represents the number of seconds used when running an

HTTPdiscovery scan.

c. In the ICMP Settings section, specify whether to ping devices that were unreachable via SNMP. Note that

this value should be set to "No" if ICMPis disabled on your network.

5. Specify read/write settings for Symbol 4131 and Cisco Aironet SNMP Initialization.

l If you select Do Not Modify SNMP Settings, then AirWave will not modify any SNMP settings. If SNMP is

not already initialized on the Symbol, Nomadix, and Cisco IOS APs, AirWave is not able to manage them.

l If you select Enable read-write SNMP, then AirWave can manage networks with Symbol, Nomadix, Cisco

IOS AP that do not have SNMP initialized.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Sin comentarios

Dell PowerConnect W-AirWave 7.6 Guía de inicio rápido Pagina 12