Dell Thin Client Solutions Manual descargar pdf (Pagina 13)

Virtual Appliance Installation & Setup | 13

Echo Network Configuration

DHCP Configuration (Default)

The next screen is the Networking configuration menu. By default, Echo will attempt

to automatically acquire an IP Address from the Dynamic Host Configuration Protocol

(DHCP) on your network. This means that your IP address will be automatically

assigned every time you reboot the machine and restart your Echo virtual application. If

DHCP assigned your Echo an IP address properly, the fourth option will read Change

eth0 inet dhcp <ip-address> <subnet mask>. Otherwise the line will just show

Change eth0 inet dhcp and you will need to assign a static IP address to the appliance.

Clicking the Change eth0 option will allow you to make changes to your Echo’s IP

configuration. If no changes are necessary, and no further configuration is required,

select No Changes and press <Enter> to continue.

Static IP Configuration

If DHCP is not available on your LAN, then you must manually set a static IP

address for the Echo server.

Select the option

Change eth0...

from the

Networking

menu.

On the next screen named

Configuring eth0

... select the

Static

option

and press the

button.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

Sin comentarios

Dell Thin Client Solutions Manual Pagina 13