Dell W-IAP103 Guía de usuario Pagina 454

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 576
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 453
454 | show spectrum-alert Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide
show spectrum-alert
show spectrum-alert
Description
This command displays the list of spectrum alerts for a W-IAP.
Syntax
Parameter Description
<count>
Filters the alerts based on the specified number.
Usage Guidelines
Use this command to view the spectrum alerts for a W-IAP. When a new non Wi-Fi device is found, an alert is
reported to the Virtual Controller. The spectrum alert messages provide information about the device ID, device type,
IP address of the spectrum monitor or hybrid AP, and the timestamp. The Virtual Controller reports the detailed
device information to W-AirWave Management server.
Example
The following example shows the output for the show spectrum-alert command when no alerts are generated.
Spectrum Alerts
---------------
Timestamp Type ID Access Point
--------- ---- -- ------------
The output of this command provides the following information:
Parameter Description
Timestamp
Displays the time at which alert was recorded.
Type
Displays the type of the device that generated the alert.
ID
Displays the device ID for which the alert is generated.
Access Point
Displays the IP address of the W-IAP.
Command History
Version Description
Dell Networking W-Series Instant 6.2.1.0-3.3
This command is introduced.
Command Information
W-IAP Platform Command Mode
All platforms
Privileged EXEC mode
Vista de pagina 453
1 2 ... 449 450 451 452 453 454 455 456 457 458 459 ... 575 576

Comentarios a estos manuales

Sin comentarios