Dell W-IAP93 Guía de usuario descargar pdf (Pagina 128)

128 | Monitoring Dell PowerConnect W-Instant Access Point 5.0.3.0-1.1.0.0 | User Guide

Figure 103 Throughput Graph

For more information about RF trends graphs in the client view and for monitoring procedures, see Table 17.

Table 17 Client View - RF Trends Graphs and Monitoring Procedures

Graph Name Description Monitoring Procedure

Signal The Signal graph shows the signal strength of

the client for the last 15 minutes. It is measured

in decibels.

To see an enlarged view, click the graph.

 The enlarged view provides Last, Minimum,

Maximum, and Average signal statistics for

the client fr the last 15 minutes.

To see the exact signal strength at a particular

time, hover the cursor over the graph line.

To monitor the signal strength of the selected client for the

last 15 minutes,

1. Log in to the Instant UI. The Virtual Controller view

appears. This is the default view.

2. In the Clients tab, click the IP address of the client for

which you want to monitor the signal strength. The

client view appears.

3. Study the Signal graph in the RF Trends pane. For

example, the graph on the left shows that signal

strength for the client is 54.0 dB at 12:23 hours.

Frames The Frames Graph shows the In and Out frame

rate per second for the client for the last 15

minutes. It also shows data for the Retry In and

Retry Out frames.

 Outgoing frames - Outgoing frame traffic is

displayed in green. It is shown above the

median line.

 Incoming frames - Incoming frame traffic is

displayed in blue. It is shown below the

median line.

 Retry Out - Retries for the outgoing frames is

displayed in black and is show above the

median line.

 Retry In - Retries for the incoming frames is

displayed in red and is shown below the

median line.

To see an enlarged view, click the graph.

 The enlarged view provides Last, Minimum,

Maximum, and Average statistics for the In,

Out, Retries In, and Retries Out frames.

To see the exact frames at a particular time,

hover the cursor over the graph line.

To monitor the In and Out frame rate per second and retry

frames for the In and Out traffic, for the last 15 minutes,

1. Log in to the Instant UI. The Virtual Controller view

appears. This is the default view.

2. In the Clients tab, click the IP address of the client for

which you want to monitor the frames. The client view

appears.

3. Study the Frames graph in the RF Trends pane. For

example, the graph on the left shows 4.0 frames per

second for the client at 12:27 hours.

Speed The Speed graph shows the data transfer speed

for the client. Data transfer is measured in Mega

bits per second (mbps).

To see an enlarged view, click the graph.

 The enlarged view shows Last, Minimum,

Maximum, and Average statistics for the

client for the last 15 minutes.

To see the exact speed at a particular time,

hover the cursor over the graph line.

To monitor the speed for the client for the last 15 minutes,

1. Log in to the Instant UI. The Virtual Controller view

appears. This is the default view.

2. In the Clients tab, click the IP address of the client for

which you want to monitor the speed. The client view

appears.

3. Study the Speed graph in the RF Trends pane. For

example, the graph on the left shows that the data

transfer speed at 12:26 hours is 240 mbps.

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 139 140

Comentarios a estos manuales

Sin comentarios

Dell W-IAP93 Guía de usuario Pagina 128

Comentarios a estos manuales

Relacionado con productos y manuales para Puntos de acceso wlan Dell W-IAP93