Dell W-IAP93 Guía de usuario descargar pdf (Pagina 55)

Dell PowerConnect W-Instant Access Point 5.0.3.0-1.1.0.0 | User Guide Managing IAPs | 55

Syslog Server

Go to Settings > Advanced > Syslog Server to specify a Syslog Server for sending all syslog messages to the

external servers.

Figure 41 Syslog Server

Adding an W-IAP to the Network

To add an W-IAP to the Dell Instant network, assign an IP address. For more information, see “Assigning an IP

Address to the W-IAP” on page18.

After an W-IAP is connected to the network, if the Auto Join Mode feature is enabled, it is listed in the Access

Points tab in the Instant UI. The W-IAP inherits the configuration and image from the virtual controller.

If the Auto Join Mode is not enabled, then perform the following steps to add an W-IAP to the network:

1. In the Access Points tab, click the New link.

Figure 42 Adding an W-IAP to the Instant Network

2. In the New Access Point box, enter the MAC address for the new W-IAP.

Figure 43 Entering the MAC Address for the New W-IAP

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 139 140

Sin comentarios

Dell W-IAP93 Guía de usuario Pagina 55