Dell PowerEdge FX2/FX2s Manual de usuario

Dell PowerEdge FN I/O Aggregator Getting Started GuideRegulatory Model: FN I/O Aggregator

Installing a switch in a Dell PowerEdge FX2 Server ChassisAfter you unpack the Aggregator, slide the switch into one of the open I/O module slots in t

2. Configure the terminal emulation software as follows:a. Select the appropriate serial port (for example, COM 1) to connect to the console.b. Set th

6Next StepsYou can customize the Aggregator for use in your data center network. To perform additional switch configuration, do one of the following:•

7Technical SpecificationsThe Aggregator is an I/O module and installed with the Dell PowerEdge FX2 server chassis for communication.NOTE: Replace the

Notes, Cautions, and WarningsNOTE: A NOTE indicates important information that helps you make better use of your computer.CAUTION: A CAUTION indicates

1About this GuideThis document helps you in getting started with Dell PowerEdge FN I/O Aggregator. For complete installation and configuration informa

2IntroductionThis document provides basic information about the Dell PowerEdge FN I/O Aggregator, including how to install and perform the initial con

3Hardware OverviewThis section contains information about input/output aggregator (IOA) characteristics and modular hardware configurations.Internal P

• Ports 9 and 10 are Fibre Channel (FC) type and support eight Gigabit FC, by default.• Ports 11 and 12 are Ethernet type and support 10 Gigabit Ether

Table 2. System LED DisplaysSystem LED LED Color/Display DescriptionPowerGreen Power is being supplied to the switch.Off The switch does not have powe

4InstallationThis switch installation procedure assumes that the Dell PowerEdge FX2 server chassis is installed correctly. For complete installation i

5Installing and Configuring the AggregatorAfter you unpack the Aggregator, refer to the following flowchart for an overview of the steps you must foll