Dell PowerVault MD3000i Manual de usuario descargar pdf (Pagina 60)

60 Installing Enclosure Components

Rotate the carrier handle to the closed position while continuing to push

the carrier into the slot.

The status LED indicator (see Table 1-3 for description) will display a

steady green if the

physical disk

is inserted properly. If the indicator is not

illuminated, see "Troubleshooting SAS Physical Disks" on page 76.

NOTE: At least two physical disks must be installed in the enclosure.

Removing and Installing a RAID Controller

Module

The enclosure contains two RAID controller modules. Both are hot-pluggable

and can be removed and installed independently without shutting down the

enclosure.

NOTICE: Removing a module is not recommended while data traffic involving that

module is occurring. Although RAID controller modules are hot-pluggable, data loss

could result from removing a module involved in data traffic.

CAUTION: Always wear a wrist grounding strap when handling equipment with

static-sensitive components. See your Product Information Guide for safety

information.

Removing a RAID Controller Module

Push up on the release tab on the left side of the module (see Figure 3-4).

At the same time, pull out on the release lever. When the lever is pulled

out, the controller module partially ejects from the

enclosure

Remove the module from the

enclosure

and place it on a flat, secure

surface.

NOTICE: To avoid damage to the sensitive EMI contacts on the bottom of the

controller module, do not stack or place it on a hard surface.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 105 106

Sin comentarios

Dell PowerVault MD3000i Manual de usuario Pagina 60