Dell PowerVault MD3000i Manual de usuario descargar pdf (Pagina 3)

Connect the expansion enclosures (if present) to the RAID controller

module you added in slot 1, as shown in Figure 2.

NOTE: Wait for the enclosure status LED to turn blue before proceeding

to the next step.

In MD Storage Manager, click the

Tools

tab (for the storage array you are

upgrading).

Select

Configure Ethernet Management Ports

, then select

Controller 1,

Port 1

in the

Ethernet port

menu.

Select

Specify configuration

Set the IP address, subnet mask, and gateway for Controller 1, Port 1.

Click

New

to add a new storage array.

In the

Add New Storage Array

window, select

Manual

and then click

The

Add New Storage Array – Manual

window opens.

Select

Out-of-band management

In the

RAID Controller Module (host name or IP address)

fields, enter

the IP addresses of both the RAID controllers now in your storage enclosure.

Click

Add

When asked if you would like to add another storage array, click

Adjust the virtual disk caching options (in each example below, the

IP_address

is the management port address of RAID controller 0):

Display a list of all virtual disks:

SMcli IP_address -c “show allVirtualDisks;”

For each virtual disk name shown, run the following command:

SMcli IP_address -c “set

virtualDisk[virtual_disk_name]

mirrorCacheEnabled=true writeCacheEnabled=true

readCacheEnabled=true;”

1 2 3 4 5 6 7 8 ... 27 28

Comentarios a estos manuales

Sin comentarios

Dell PowerVault MD3000i Manual de usuario Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Dell PowerVault MD3000i