Dell XPS 710 Manual de usuario Pagina 44

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 105
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 43
9. Connect any cables that should be attached to the card.
See the documentation for the card for information about the card's cable connections.
10. Rotate the card retainer back into its original position; push its tip so that its tab clicks into place.
11. If present, lower the card retention device that lays over the installed cards and snap it into place.
12. Replace the computer cover (see Replacing the Computer Cover), reconnect the computer and devices to electrical outlets, and then turn them on.
13. Install any drivers required for the card as described in the card documentation.
Removing a PCI Express Graphics Card from a Dual Configuration
1. Follow the procedures in Before You Begin.
2. Remove the computer cover (see Removing the Computer Cover).
3. If present, press the tab on the card retention device that lays over the installed cards and rotate it upwards to gain full access to the card.
4. Gently securing both graphics cards with one hand, remove the graphics card bridge (if present) with your other hand by pulling it up and away from the
computer. Set it aside.
1
card connector (seated)
2
card connector (not
seated)
3
bracket properly aligned
within slot
4
bracket improperly aligned
outside of slot
5
alignment bar
6
alignment guide
NOTICE: An incorrectly attached graphics power cable may result in degraded graphics performance.
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug the cable into the computer.
NOTE: If you installed a sound card or a network adapter, see Network Adapter and Sound Card Settings.
NOTE: This section regards dual configurations of PCI Express x16 graphics cards only. For removal of any other type of PCI or PCI Express cards, see
Removing PCI and PCI Express Cards.
Vista de pagina 43
1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 104 105

Comentarios a estos manuales

Sin comentarios