Dell Management Plug-in for VMware vCenter version 1.0.1 Manual de usuario descargar pdf (Pagina 38)

38 Plug-In Configuration

Figure 2-22. Configure user

To disable a user, uncheck the

Enable User

check box and click

Apply

enable a user, check the

Enable User

check box and click

Apply.

Manually close the iDRAC user interface, then reboot the system and log

back in.

When the system reboots, enter

ctrl-E

when the iDRAC IP address is

displayed, and then go to

LAN USER CONFIGURATION

and set the

AutoDiscovery Flag

Enable

; make sure the iDRAC administrator

accounts are disabled. Alternatively, to set up the network for auto

discovery and handshake, refer to the

Dell Auto-Discovery Network Setup

Specification

located at:

http://www.delltechcenter.com/page/Lifecycle+Controller

Enter the plug-in appliance IP address in the

Provisioning server

field, and

click enter and save to initiate discovery and initial start-up.

Installation and configuration is complete, and the Dell Management Plug-In

is ready for use.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 113 114

Sin comentarios

Dell Management Plug-in for VMware vCenter version 1.0.1 Manual de usuario Pagina 38