Dell Networking S6000 Guía de inicio rápido descargar pdf (Pagina 11)

Hardware Overview 7

Utility Panel

The Utility panel side contains the fan and power modules.

Figure 3-2

shows the

S6000 power supplies and fan modules.

Figure 3-2. S6000 Power Supplies and Fan Modules

1 - PSU 0

2 - Fan Modules 0-2

3 - PSU 1

Power Supplies

The S6000 supports two hot-swappable Power Supply Units (PSUs). The S6000

supports AC and DC power supplies with two air-flow directions (I/O to PSU

and PSU to I/O). Two PSUs are required for full redundancy, but the system can

operate with a single PSU.

NOTE: If you use a single PSU, install a blank plate in the other PSU slot. Dell

Networking recommends using power supply 1 (PSU1) as the blank plate slot.

The PSUs are field replaceable. When running with full redundancy (two power

supplies installed and running), you can remove and replace one PSU while the

other PSU is running without disrupting traffic.

The S6000 does not support mixing PSU types. You cannot replace an AC PSU

with a DC PSU and you cannot replace an AC-R PSU with a DC-R PSU.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 36 37

Sin comentarios

Dell Networking S6000 Guía de inicio rápido Pagina 11