Dell Networking S6000 Guía de inicio rápido descargar pdf (Pagina 35)

Installing the Software 31

To view which interfaces are tagged or untagged and to view which VLAN the

interfaces belong, use the show vlan command. To view just the interfaces that

are in Layer 2 mode, use the show interfaces switchport command in EXEC

Privilege mode or EXEC mode.

To tag frames leaving an interface in Layer 2 mode, assign that interface as

tagged to a port-based VLAN to tag it with that VLAN ID.

To tag interfaces, follow these steps.

To move untagged interfaces from the Default VLAN to another VLAN, use the

untagged command.

To move untagged interfaces, follow these steps.

Step Task Command Syntax Command Mode

1 Access INTERFACE

VLAN mode of the

VLAN to which you

want to assign the

interface.

interface vlan vlan-id CONFIGURATION

2 Enable an interface to

include the IEEE

802.1Q tag header.

This command is

available only in

VLAN interfaces.

tagged interface INTERFACE

Step Task Command Syntax Command Mode

1 Access INTERFACE

VLAN mode of the

VLAN to which you

want to assign the

interface.

interface vlan vlan-id CONFIGURATION

2 Configure an interface

as untagged. This

command is available

only in VLAN

interfaces.

untagged interface INTERFACE

1 2 ... 30 31 32 33 34 35 36 37

Sin comentarios

Dell Networking S6000 Guía de inicio rápido Pagina 35