Dell Lifecycle Controller 1.5 Manual de usuario Pagina 114

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 132
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 113
114 Troubleshooting and Frequently Asked Questions
Failed to copy to Network
Share
This error may occur due to temporary network
problems. If this issue persists, check the network
connection and then retry.
Failed to log the message Ensure that these characters are not used in the
message: <, >, &, and %. If the issue persists, reboot
iDRAC.
Failed to Open Dell Update
Package File
Use the correct DUP, name, and path.
Invalid USB Folder
Location
Provide the valid folder location.
Invalid Network Share
Folder Location
Provide the valid folder location.
Invalid USB and Network
Share Folder Location
Provide the valid folder location.
Failed to copy to USB
Device. Destination folder
not present
Ensure that the folder exits, or create the folder and
retry.
Failed to copy to Network
Share. Destination folder
not present
Ensure that the folder exists, or create a folder and retry.
The Update Package is not
supported for this System
Ensure that the DUP is supported on the system.
Invalid Update Package Ensure that the DUP is not corrupt or tampered.
The backup operation that
was initiated from USC
completed with errors. For
more information, refer to
the RAC log.
The RAC log contains the names of the components
that failed during backup. Verify the firmware
information and retry.
Initiating backup failed.
Retry after few minutes.
Perform A/C power cycle and retry.
Copying backup file to the
SRVCNF partition on the
vFlash SD card failed.
Make sure that the vFlash SD card is installed,
initialised, and enabled.
Table 5-3. USC-LCE Error Messages and Resolutions
(continued)
Error Message Resolution
Vista de pagina 113
1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 131 132

Comentarios a estos manuales

Sin comentarios