
Troubleshooting and Frequently Asked Questions 117
2
Connect to iDRAC on your system using the iDRAC Web interface.
For
more information on iDRAC, see the
Integrated Dell Remote Access
Controller 6 (iDRAC6) User’s Guide
.
3
From the iDRAC Web interface, click
Remote Access
.
4
Select the
Update
tab, and then browse to USC-LCE Repair Package you
downloaded from
ftp.dell.com
.
5
Click
Next
, and then click
OK
to confirm the upload. Allow the process to
complete before you continue to
step 6.
6
Reboot your system, and then press the
<F10>
key to enter USC-LCE.
7
Complete the installation of all recommended updates. See Updating
Platform for more information. When updates are complete, your system
automatically reboots.
8
While the system reboots, press the
<F10>
key again to enter
USC - LCE
.
If a warning message appears on the initial
USC-LCE
screen, you must
repeat
step 7 until the server is in a fully-recovered state.
NOTE: Updates that are required for a complete system recovery are pre-
selected by USC-LCE. It is highly recommended that you run all the selected
updates on the system.
Comentarios a estos manuales