Dell PowerEdge 1850 Guía para resolver problemas descargar pdf (Pagina 6)



4. If you removed the riser card insulator in step 3, reinstall it now. See "Installing the Riser Card" in "Installing System Components."



5. Close the system. See "Closing the System" in "Troubleshooting Your System."



6. Reconnect the system to the electrical outlet, and turn on the system.

The existing passwords are not disabled (erased) until the system boots with the password jumper plug removed. However, before you assign a new

system and/or setup password, you must install the jumper plug.



7. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.



8. Open the system.



9. Install the password jumper plug.

See FigureA-2 to locate the password jumper on the system board.

If necessary, remove the riser card insulator to improve access to the jumper, then reinstall the riser card insulator.



10. Close the system, reconnect the system to the electrical outlet, and turn on the system.



11. Assign a new system and/or setup password.

To assign a new password using the System Setup program, see "Using the System Setup Program" in your User's Guide.

Back to Contents Page



NOTE: If you assign a new system and/or setup password with the jumper plug still removed, the system disables the new password(s) the next

time it boots.

1 2 3 4 5 6 7 8 9 10 11 ... 72 73

Sin comentarios

Dell PowerEdge 1850 Guía para resolver problemas Pagina 6