Dell PS4100 Guía de instalación descargar pdf (Pagina 14)

PS4100 Installation Guide Rack Mounting the Array

correct type of voltage for an adequate amount of time.

Steps for Mounting an Array in a Rack

Follow these steps to mount an array in a rack:

1. Determine where to place the mounting rails in the rack.

2. Attach the mounting rails to the rack.

3. Slide the chassis into the rack.

4. Attach the chassis to the front of the mounting rails.

5. Install the bezel.

These steps are described in detail in the following sections.

Installing the Rails and System in a Rack

Install the rails in the rack following the safety instructions and the rack installation instructions provided

with your rail kit.

If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack

environment may be greater than room ambient. Therefore, make sure you install the equipment in an

environment compatible with the maximum ambient temperature (Tma) specified by the manufacturer. For

more information, see Technical Specifications on page 35.

Determine Where to Place the Mounting Rails in the Rack

Make sure there is enough space in the rack for the chassis. In a standard rack, a 2U chassis will span six

holes.

Slide the Chassis into the Rack

Figure 2 shows the front view of the 3.5-inch drive array.

Figure 2 3.5-Inch Drive Array - Front View (without Bezel)

Figure 3 shows the front view of the 2.5-inch drive array.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 48 49

Sin comentarios

Dell PS4100 Guía de instalación Pagina 14