Dell PS4100 Guía de instalación descargar pdf (Pagina 28)

PS4100 Installation Guide Software Configuration

Network interface [eth0]: eth0

IP address for network interface []: 192.17.2.41

Netmask [255.255.255.0]:

Default gateway [192.17.2.1]:

Enter the name and IP address of the group that the array will join.

Group name []: group1

Group IP address []: 192.17.2.20

Searching to see if the group exists. This may take a few minutes.

The group does not exist or currently cannot be reached. Make sure you have entered the

correct group IP address and group name.

Do you want to create a new group (yes | no) [yes]? yes

Group Configuration

Group Name: group1

Group IP address: 192.17.2.20

Do you want to use the group settings shown above (yes | no) [yes]: yes

Password for managing group membership:

Retype password for verification:

Password for the default group administration account:

Retype password for verification:

Saving the configuration ...

Waiting for configuration to become active......Done

Group member member1 now active in the group.

Group group1 has been created with one member.

Use the Group Manager GUI or CLI to set the RAID policy for the member. You can then

create a volume that a host can connect to using an iSCSI initiator.

group1>

Using the Remote Setup Wizard to Configure the Software

The Remote Setup wizard is located on the Host Integration Tools CD-ROM and must be installed on a

Windows computer. The Host Integration Tools User Guide provides detailed information about using the

full capabilities of the Remote Setup Wizard.

To run the Remote Setup Wizard, follow these steps:

1. Use a computer that meets the requirements in Choose a Configuration Method on page 17.

2. Obtain the Host Integration Tools CD-ROM from the shipping box, or download the Host Integration

Tools kit from the support website.

3. Install the Remote Setup Wizard following the instructions in the Host Integration Tools documenta-

tion.

4. Start the Remote Setup Wizard by clicking:

Start, Programs, EqualLogic, Remote Setup Wizard

5. In the Welcome dialog box, select Initialize a PS Series array and click Next.

Note: If you cannot contact the array, check the network configuration. You may need to use the

setup

utility to configure the software.

6. Select the array that you want to initialize and click

Next.

7. In the Initialize Array dialog box, enter the array configuration from Table 6 and choose to create a

group or join an existing group. Then, click

Next.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 48 49

Comentarios a estos manuales

Sin comentarios

Dell PS4100 Guía de instalación Pagina 28

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores Dell PS4100