Dell PowerConnect W-AirWave 7.4 Manual de usuario descargar pdf (Pagina 21)

Dell PowerConnect W-AirWave 7.4 | Configuration Guide Dell PowerConnect W Configuration in AirWave | 21

Dell PowerConnect W Configuration includes several settings or functions that are dependent on special

licenses. The user interface conveys that a special license is required for any such setting, function, or profile.

AirWave does not push such configurations when a license related to those configurations is unavailable. For

details on the licenses required by a specific version of AOS, refer to the Dell PowerConnectW-AirWave User

Guide on support.dell.com/manuals for that release.

Setting Up Initial Dell PowerConnect W Configuration

This section describes how to deploy an initial setup of Dell PowerConnect W Configuration in AirWave.

Prerequisites

 Complete the Dell PowerConnect W-AirWave 7.4 upgrade to AirWave 6.4 or later. Upon upgrade to

AirWave version 6.4 or later, global Dell PowerConnect W Configuration is enabled by default in groups with

devices in monitor-only mode.

 Back up your AOS controller configuration file. Information about backing AirWave is available in the Dell

PowerConnect W-AirWave 7.4 User Guide on support.dell.com/manuals in the “Performing Daily Operations

in AirWave” chapter.

Procedure

Perform the following steps to deploy Dell PowerConnect W Configuration when at least one Dell

PowerConnect W AP Group currently exists on at least one Dell PowerConnect W-Series controller on the

network:

1. Determine whether you are using global or group configuration, and set AMP Setup > General > Device

Configuration > Use Global Dell PowerConnect W Configuration accordingly.

2. On the Groups > Basic page, enable device preferences for Dell PowerConnect W-Series devices. This

configuration defines optional group display options. This step is not critical to setup, and default settings will

support groups appropriate for Dell PowerConnect W Configuration. One important setting on this page is

the Dell PowerConnect W GUI Config option. Ensure that setting is Yes, which is the default setting.

3. Authorize Dell PowerConnect W controllers into the device group in Monitor Only mode.

4. Navigate to the AP/s/Devices > Audit page for the first controller to prepare for importing an existing Dell

PowerConnect W-Series controller configuration file. Figure 14 illustrates the information available on this

page if the device is mismatched.

Figure 14 APs/Devices > Audit Page Illustration

CAUTION: When authorizing the first controller onto a device group, you must add the device in monitor-only mode. Otherwise,

AirWave removes the configuration of the controller before you have a chance to import the configuration, and this would

remove critical network configuration and status.

NOTE: Dell PowerConnect W Configuration is enabled by default in AirWave.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 171 172

Sin comentarios

Dell PowerConnect W-AirWave 7.4 Manual de usuario Pagina 21