Dell PowerConnect W-AirWave 7.4 Manual de usuario descargar pdf (Pagina 9)

Dell PowerConnect W-AirWave 7.4 | Configuration Guide Dell PowerConnect W Configuration in AirWave | 9

Chapter 1

Dell PowerConnect W Configuration in

AirWave

Introduction

ArubaOS (AOS) is the operating system, software suite, and application engine that operates Dell PowerConnect

W-Series mobility controllers and centralizes control over the entire mobile environment. The AOS wizards,

command-line interface (CLI), and the AOS WebUI are the primary means used to configure and deploy AOS.

For a complete description of AOS, refer to the Dell PowerConnect W-Series ArubaOS User Guide at

support.dell.com/manuals for your release.

The Dell PowerConnect W Configuration feature in AMP consolidates AOS configuration and pushes global

Dell PowerConnect W configurations from one utility. This chapter introduces the components and initial setup

of Dell PowerConnect W Configuration with the following topics:

 Requirements, Restrictions, and ArubaOS Support in AirWave

 Additional Concepts and Components of Dell PowerConnect W Configuration

 Setting Up Initial Dell PowerConnect W Configuration

Requirements, Restrictions, and ArubaOS Support in AirWave

Requirements

Dell PowerConnect W Configuration has the following requirements in AirWave:

 AirWave 6.3 or a later AirWave version must be installed and operational on the network.

 Dell PowerConnect W-Series controllers on the network must have AOS installed and operational.

 For access to all monitoring features, you must provide Telnet/SSH credentials for a user with minimum

access level of read only. In order to perform configuration, the credentials must be for a root level user. In

either case, the “enable” password must be provided.

Restrictions

Dell PowerConnect W Configuration has the following restrictions in AirWave:

 At present, Dell PowerConnect W Configuration in AirWave does not support every AOS network

component. For example, AirWave supports only IP Mobility and VLANs in the Advanced Services section.

 AOS Configuration is not supported in either Global Groups or the Master Console. Appropriate options will

be available in the Subscriber Groups containing the controller(s).

ArubaOS Support in AirWave

AMP provides three options for configuring Dell PowerConnect W-Series devices:

 Global GUI config for organizations who have near-identical deployments on all of their controllers

 Group-level GUI config for organizations who have two or more configuration strategies

NOTE: AirWave supports Dell PowerConnect W AP Groups which should not be confused with standard AirWave Device Groups.

This document provides information about the configuration and use of Dell PowerConnect W AP Groups, and describes how Dell

PowerConnect W AP Groups interoperate with standard AirWave Device Groups.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 171 172

Sin comentarios

Dell PowerConnect W-AirWave 7.4 Manual de usuario Pagina 9