Dell PowerConnect W-Clearpass 100 Software Guía de usuario descargar pdf (Pagina 391)

ClearPass Guest 3.9 | Deployment Guide Administrator Tasks | 391

attention. Use the Disable Check link to prevent the security audit from raising warnings about a specific

security condition.

Changing Network Security Settings

Use the Network Security command link to check the current settings for remote console access.

ClearPass Guest has a command line interface(CLI) which may be accessed using the appliance console or

SSH.

Typical usage scenarios where command line access might be used are:

 Changing the initial network configuration of the appliance

 Resetting the appliance to factory default settings

 Resetting a forgotten ‘admin’ operator login password

 Rebooting the appliance

 Enabling or disabling remote SSH access

Command line access is not required to perform any normal configuration or management tasks, and

should never be required after the initial setup has been completed.

For this reason, SSH access has been disabled by default. It is recommended to leave this network service

disabled unless you have specific requirements to the contrary.

Network access restrictions for SSH console access may be specified using the Network Login Access

form for operator logins. This can be used to ensure that guests do not have SSH console access, even if it is

enabled for operators; See “Creating a VLAN Interface” in this chapter for details on configuring the access

control list for operators.

Resetting the Root Password

The root password is required to log into the appliance’s console user interface (either directly at the

console, or remotely via SSH). See “Console Login” in the Setup Guide chapter for an explanation.

The default root password for the appliance is admin.

During the initial setup wizard, the root password is updated to correspond to the administrator’s

password.

Once you have set the initial root password, future changes to the administrator password will not change

the appliance’s root password.

In order to recover from a forgotten root password, you must have administrative access to the graphical

user interface. Navigate to Administrator > Security Manager, click the Network Security command

link, and then click the Reset Root Password link at the bottom of the page.

Provide your current operator password, and confirm the new root password by entering it in the

appropriate fields. Click theSet Password button to have the new root password take effect.

Notifications

Operators with the IT Administrator profile can choose to receive warning notifications by email when disk

space is low. You can configure notification frequency according to remaining disk space, or disable

notifications.

The Reset Root Password form is only available to operators with both the Plugin Manager and Network Setup

privileges.

1 2 ... 386 387 388 389 390 391 392 393 394 395 396 ... 517 518

Sin comentarios

Dell PowerConnect W-Clearpass 100 Software Guía de usuario Pagina 391