Dell Acceleration Appliances for Databases Manual de usuario descargar pdf (Pagina 40)

Configuring Multipathing on Windows

_____________________________________________________________________

INSTALLING MULTIPATH ON WINDOWS

When MPIO is installed, the Microsoft device-specific module (DSM) and the MPIO Control Panel are

also installed.

For additional information on Windows MPIO settings, refer to

http://blogs.msdn.com/b/san/archive/2011/12/02/updated-guidance-on-microsoft-mpio-settings.aspx

In Windows 2008 R2 SP2, disk I/O operations may fail even when valid failover paths exist. To

resolve this problem, apply the Microsoft hotfix available at

http://support.microsoft.com/kb/2752538/en-us

Installing Multipath on Windows Server 2008

To install MPIO on a server running Windows Server 2008 R2,

1. Open Server Manager (Start > Administrative Tools > Server Manager).

2. In the Server Manager tree, click Features.

3. In the Features area, click Add Features.

4. In the Add Features Wizard, on the Select Features page, select the Multipath I/O check box,

and then click Next.

5. On the Confirm Installation Selections page, click Install.

6. When the installation finishes, on the Installation Results page, click Close.

7. When prompted to restart the computer, click Yes. After restarting, the computer finalizes

the MPIO installation.

8. Click Close.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 88 89

Sin comentarios

Dell Acceleration Appliances for Databases Manual de usuario Pagina 40