Dell PowerVault DP100 Manual de usuario descargar pdf (Pagina 35)



1. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.



2. Remove the bezel. See Removing the Bezel.



3. Lay the system on its right side.



4. Loosen the thumbscrew at the front of the system. See Figure3-3.



5. Slide the cover forward and grasp it at both ends.



6. Lift the front edge of the cover 2.5 cm (1 inch), slide the cover toward the top of the system, and then lift the cover away from the system.

Figure 3-3. Removing the Cover

Front-Panel Drive Inserts

To help keep dust and dirt out of the system, a plastic insert covers each empty external drive bay. Additionally, each empty external drive bay is covered by a

metal insert in the chassis to maintain Federal Communications Commission (FCC) certification of the system.

Before you install a 5.25-inch drive in an empty external drive bay, you must first remove both front-panel drive inserts. If you remove a 5.25-inch drive

permanently, you must install both inserts.



Removing the Front-Panel Drive Inserts



1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.



2. Remove the bezel. See Removing the Bezel.



3. Remove the bezel drive insert (see Figure3-4):

a. From inside the bezel, press the center of the insert outward with your thumbs to loosen the tabs on the sides of the insert.

b. Pull the insert out of the bezel.



4. Remove the chassis drive insert (see Figure3-4):

a. Press both sides of the insert to loosen the tabs on the insert.

b. Pull the insert out of the chassis.

Figure 3-4. Removing the Front-Panel Drive Inserts

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system.

Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the

computer and protecting against electrostatic discharge.

system cover

thumbscrew

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system.

Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the

computer, and protecting against electrostatic discharge.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 87 88

Comentarios a estos manuales

Sin comentarios

Dell PowerVault DP100 Manual de usuario Pagina 35

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Dell PowerVault DP100