Dell PowerVault DP100 Manual de usuario descargar pdf (Pagina 42)



1. Unpack the drive (and controller card, if applicable), and prepare the drive for installation.

For instructions, see the documentation that accompanied the drive.



2. Install the hard drive in the hard-drive bay:

a. Slide the drive into the drive bay with the back of the drive toward the back of the drive bay.

b. Install the screws that secure the drive in the drive bay.



3. Install the hard-drive bay. (See Figure3-8.):

a. Slide the drive bay into the system until the drive bay contacts the system.

b. Install the three screws that secure the drive bay in the system.



4. Connect a power cable to each hard drive. (See Figure3-8.)



5. Connect the hard-drive interface cables to each hard drive.

¡ If you are installing a SATA hard drive, connect the SATA interface cable to the hard drives and to the SATA ports on the system board. (See

Figure3-9.)

¡ If you are installing a SAS drive, connect the SAS interface cable to the hard drives and to the optional SAS controller card. (See Figure3-10.)

Figure 3-9. Connecting SATA Hard Drives to the Integrated Drive Controller

Figure 3-10. Connecting SATA Drives to a SAS Controller Card

(SAS backplane not installed)

NOTE: Hot-plug capability is supported only when the SAS backplane is installed. For more information, see Hot-Plug SATA Hard Drives Using the SAS

Backplane.

NOTICE: To prevent damage to internal system components, ensure that a connector cap is installed on each available power connector that is not

connected to a hard drive.

SATA hard drive (up to four)

SATA interface cable

SATA_1 connector

SATA_0 connector



1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 87 88

Sin comentarios

Dell PowerVault DP100 Manual de usuario Pagina 42