Dell PowerVault DP100 Manual de usuario descargar pdf (Pagina 45)



2. Open the system. See Opening the System.



3. Remove all existing hard drives from the hard drive bay. See Removing a Hard Drive from the Drive Bay.



4. Install the SAS backplane:

a. Lower the backplane into the system and align the backplane with the retention hooks on the drive bay, then fit the backplane over the

retention hooks.

b. Slide the backplane board toward the front fan about 12 mm (0.5 inch) until it clicks into place.

Figure 3-12. Installing the SAS Backplane Board



5. Connect the power cable connector P3 to the power connector on the SAS backplane. See Figure3-12.



6. Connect the baseboard management controller (BMC) inter-IC (I2C) cable to the SAS backplane. See Figure3-12.



7. Connect the other end of the BMC I2C cable to connector BP_I2C on the system board. See System Board Connectors.



8. If not already installed, install the SAS controller card.

See Installing an Expansion Card for instructions about installing the card.



9. Connect the SAS data cable to the SAS controller card, and to the SAS interface connector on the backplane. See Figure3-13 and Figure3-12.



10. Close the system. See Closing the System.



11. Stand the system upright.



12. Install the hard drives into the hard-drive bay. See Figure3-11.



13. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.



14. Install any required device drivers.



15. Run the SAS controllers tests and the hard-drive tests in the system diagnostics. See Running the System Diagnostics.

Installing SATA and SCSI hard drives in the same system is not supported.

Figure 3-13. SAS Backplane Connected to a SAS Controller Card

release tab

power connector

I2C connector

data cable

power cable



1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 87 88

Sin comentarios

Dell PowerVault DP100 Manual de usuario Pagina 45