Dell PowerVault NX3610 Especificaciones descargar pdf (Pagina 8)

4. Complete the cabling of the NAS controller(s) and the MD storage array(s) with the management station, SAN

network, and the client network.

5. Connect the management station to the same switch as the client connections on your NAS controller(s).

For more information on cabling for your particular topology, see Cabling Overview.

6. Complete the PowerVault FluidFS NAS Setup worksheet.

For more information, see PowerVault FluidFS NAS Setup Worksheet.

7. Complete the configuration of your management station.

For more information, see Preparing Your Management Station.

8. Install and run the NAS IDU on the management station that has IPv6 enabled.

For more information, see Running PowerVault NAS IDU.

9. Set up your MD storage array using the MDSM.

For more information, see Setting Up Your MD Storage Solution.

10. Run the NAS Manager Configuration Wizard.

For more information, see NAS Manager Configuring Wizard.

Choosing The Switch Topology

The PowerVault NX3600/NX3610 supports multiple switch topologies. Choose the ideal topology for your environment

and cable the solution accordingly. For more information on the cabling requirements for each of the topologies, see

Cabling Overview.

Table 2. Switch Topologies for PowerVault NX3600/NX3610 in the Non-Redundant and High Availability Options

Topology Number of Switches Description

Dedicated SAN — High Availability (HA) 4 This topology leverages the best practices

of the industry relating to iSCSI and

separates the SAN and LAN/Client traffic.

The client cables are connected to a client

switch and the SAN cables are connected

to a SAN switch.

NOTE: Dedicated SAN-High

Availability (HA) is the recommended

topology.

Dedicated SAN — Non-Redundant 2

All-in-one solution — HA 2 A basic topology where the SAN and the

client cables are connected to the same

switch.

All-in-one solution — Non-Redundant 1

Ensure the following settings are enabled in the SAN and client switches:

Table 3. Switch Settings

Client/Primary Network SAN Network

Jumbo Frames Enabled (9216 MTU) Recommended Required

Portfast Enabled Required Required

Flow Control Enabled Recommended Required

IPv6 Required (during initial deployment) Required

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 36 37

Sin comentarios

Dell PowerVault NX3610 Especificaciones Pagina 8