Dell PowerEdge 2850 Guía para resolver problemas descargar pdf (Pagina 53)



3. Press the tab on the end of one of the heat-sink retention levers to disengage the lever, then lift the lever 90 degrees. See Figure6-6.

Figure 6-6. Installing and Removing the Heat Sink



4. Wait 30 seconds for the heat sink to loosen from the processor.



5. Repeat step 3 to open the other heat sink retention lever.



6. Remove the heat sink.

a. If the processor is removed from the socket with the heat sink, twist or slide the processor off of the heat sink. Do not pry the processor off of

the heat sink.

b. Set the heat sink upside down so as not to contaminate the thermal grease.



7. Pull the socket-release lever straight up until the processor is released from the socket. See Figure6-7.

Figure 6-7. Installing and Removing the Processor



8. Lift the processor out of the socket and leave the release lever up so that the socket is ready for the new processor.



NOTICE: The processor and heat sink can become extremely hot. Be sure the processor has had sufficient time to cool before handling.

NOTICE: Never remove the heat sink from a processor unless you intend to remove the processor. The heat sink is necessary to maintain proper

thermal conditions.

NOTE: When removing the heat sink, the possibility exists that the processor might adhere to the heat sink and be removed from the socket. It is

recommended that you remove the heat sink while the processor is still warm.

NOTICE: Be careful not to bend any of the pins when removing the processor. Bending the pins can permanently damage the processor.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 75 76

Comentarios a estos manuales

Sin comentarios

Dell PowerEdge 2850 Guía para resolver problemas Pagina 53

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores Dell PowerEdge 2850