
priority group. The range is 1 to 100. The sum of all allocated
bandwidth percentages in priority groups in a DCB map must
be 100%.
• strict-priority = Configure the priority-group traffic
to be handled with strict priority scheduling. Strict-priority
traffic is serviced first, before bandwidth allocated to other
priority groups is made available.
• pfc {on | off} = Configure whether priority-based flow
control is enabled (on) or disabled (off) for port traffic in the
Use this command to configure PFC and ETS traffic handling for each
priority group in a DCB map.
You can enable PFC on a maximum of two priority queues.
If you configure more than one priority group as strict priority, the
higher numbered priority queue is given preference when
scheduling data traffic.
If a priority group does not use its allocated bandwidth, the unused
bandwidth is made available to other priority groups.
By default, equal bandwidth is assigned to each dot1p priority in a
priority group.
Use the bandwidth parameter to configure the bandwidth
percentage assigned to a priority group. The sum of the bandwidth
allocated to all priority groups in a DCB map must be 100% of the
bandwidth on the link.
You must allocate at least 1% of the total port bandwidth to each
•
•
show fcoe-map
Display the Fibre Channel and FCoE configuration parameters in FCoE maps.
show fcoe-map [brief | map-name]
• brief = Displays an overview of currently configured FCoE
maps.
• map-name = Displays the FC and FCoE configuration
parameters in a specified FCoE map. The FCoE map is applied
on Ethernet (FCoE) and FC ports to transmit FC storage traffic
Comentarios a estos manuales