Dell PowerConnect W-AirWave 7.6 Manual de usuario descargar pdf (Pagina 144)

132 | Discovering, Adding, and Managing Devices Dell PowerConnect W-AirWave 7.6 | User Guide

Compare two configurations to highlight the specific lines that are mismatched. The Audit page provides links to

the AirWave pages where any mismatched settings can be configured.

NOTE: These procedures assume you are familiar with the function buttons available to save, apply, revert, and so on. For details on

button functions, see Buttons and Icons in the Dell PowerConnect W-AirWave 7.6 Installati on Guide.

Moving a Device from Monitor Only to Manage Read/Write Mode

Once the device configuration status is Good on the APs/Devices > List page, or once you have verified all changes

that will be applied to the device on the APs/Devices > Audit page, you can safely shift the device from Monitor

Only mode to Manage Read/Write mode.

NOTE: When a device is in Manage mode, AirWave will push a new configuration to the device in the event that the actual device

configuration does not match the AirWave configuration for that device.

To move a device from Monitor Only to Manage Read/Write mode, perform the following steps.

1. Go to the APs/Devices > List page and select the wrench icon next to the name of the AP to be shifted from

Monitor Only mode to Manage Read/Write mode. This directs you to the APs/Devices > Manage page.

2. Locate the General area as shown in Figure 97.

Figure 97: APs/Devices > Manage > General Section Illustration

3. Select Manage Read/Write on the Management Mode field.

4. Select Save and Apply, then Confirm Edit on the confirmation page to retain these settings and to push

configuration to the device.

5. For device configuration changes that require the device to reboot, use the Schedule function to push the

changes at a time when WLAN users will not be affected.

6. To move multiple devices into managed mode at once, use the Modify Devices link on an AP list page. For more

information, refer to "Modifying Multiple Devices" on page 95.

NOTE: Use the Enable Planned Maintenance Mode field in APs/Devices > Manage > General to put this device into planned

maintenance. During the maintenance mode, no AP Down triggers will be deployed on these devices. Users will not be able to delete

folders that contain devices in Planned Maintenance. The devices in Planned Maintenance will show the Up status, but will not be

tracked in historical graphs and logs as Up. You can set multiple devices into Planned Maintenance Mode in the Modify Devices link

on an AP list page.

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 331 332

Sin comentarios

Dell PowerConnect W-AirWave 7.6 Manual de usuario Pagina 144