Dell PowerConnect W-AirWave 7.6 Manual de usuario descargar pdf (Pagina 174)

162 | Creating and Using Templates Dell PowerConnect W-AirWave 7.6 | User Guide

%avt_ingress_interface%

%avt_ingress_ip%

buffer_time 200

mode %avt_mode%

NOTE: AirWave displays a warning if AirMesh APs attempting to either upgrade or push configurations lack the necessary write

permissions.

Configuring Cisco IOS Templates

Cisco IOS access points have hundreds of configurable settings. AirWave enables you to control them via the

Groups > Templates configuration page. This page defines the startup-config file of the devices rather than using

the AirWave normal Group configuration pages. AirWave no longer supports making changes for these devices via

the browser-based page, but rather uses templates to configure all settings, including settings that were controlled

formerly on the AirWave Group configuration pages. Perform these steps to configure a Cisco IOS Template for use

with one or more groups, and the associated devices.

This section includes the following topics:

l "Applying Startup-config Files" on page 162

l "WDS Settings in Templates" on page 162

l "SCP Required Settings in Templates" on page 163

l "Supporting Multiple Radio Types via a Single IOS Template" on page 163

l "Configuring Single and Dual-Radio APs via a Single IOS Template" on page 164

Applying Startup-config Files

Each of the APs in the Group copies its unique startup-config file from AirWave via TFTP or SCP.

l If the Reboot Devices after Configuration Changes option is selected, then AirWave instructs the AP to copy

the configuration from AirWave to the startup-config file of the AP and reboot the AP.

l If the Reboot Devices after Configuration Changes option is not selected, then AirWave instructs the AP to

copy the configuration to the startup-config file and then tell the AP to copy the startup config file to the

running-config file. Use the reboot option when possible. Copying the configuration from startup to running

merges the two configurations and can cause undesired configuration lines to remain active on the AP.

NOTE: Changes made on the standard AirWave Group configuration pages, to include Basic, Radio, Security, VLANs, and so forth,

are not applied to any template-based APs.

WDS Settings in Templates

A group template supports Cisco WDS settings. APs functioning in a WDS environment communicate with the

Cisco WLSE via a WDS master. IOS APs can function in Master or Slave mode. Slave APs report their rogue

findings to the WDS Master (AP or WLSM which reports the data back to the WLSE. On the APs/Devices >

Manage configuration page, select the proper role for the AP in the WDS Role drop down menu.

The following example sets an AP as a WDS Slave with the following lines:

%if wds_role=client%

wlccp ap username wlse password 7 XXXXXXXXXX

%endif%

The following example sets an AP as a WDS Master with the following lines:

%if wds_role=master%

aaa authentication login method_wds group wds

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 331 332

Sin comentarios

Dell PowerConnect W-AirWave 7.6 Manual de usuario Pagina 174