
478 vFoglight
Administration and Configuration Guide
To specify topology type properties:
Note This procedure continues from “Restricting the scope to topology objects” on page 476.
1
In the Scoping Query Editor dialog box, click the Filter tab.
The Filter tab opens in the Scoping Query Editor dialog box, allowing you to
create a logical expression containing up to three comparison expressions that are
connected with “AND” or “OR” logical operators.
2
To specify a comparison expression, complete the following steps.
a
In the Filter tab, click Properties and select a property.
b
Click is equal to on the right and select a logical operator from the list that
appears: is equal to, is not equal to, is like, or is not like.
c
In the box to the right of the one containing the newly-selected logical
operator, type the property value that you want to use in the filter.
3
If you do not want to add more comparison expressions to the filter, click and on
the right and select the blank entry.
4
If you want to add more expressions to the filter, repeat step 2 and set the logical
operators at the end of each line as required.
Note If you need to define more than three expressions in the filter, you can add them
after closing the Scoping Query Editor dialog box.
5
Click Insert Query.
Comentarios a estos manuales