Dell AX4-5 Especificaciones descargar pdf (Pagina 45)

naviseccli –h SP ipaddress mirror –sync –addimage –name <name>

-arrayhost <sp-hostname| sp ipaddress> -lun <lunnumber| lun uid>

4. Even if there is only a single LUN being replicated to the secondary site, you still need to

create a consistency group for SRM. The following commands show how to create a

consistency group and add existing mirrors to the consistency group.

naviseccli –h SP ipaddress mirror –sync –creategroup –name <name>

naviseccli –h SP ipaddress mirror –sync –addgroup –name <name>

-mirrorname <mirrorname>

5. If for some reason the mirrors are fractured, the syncgroup option (shown below), can be

used to resynchronize the primary and secondary images:

naviseccli –h SP ipaddress mirror –sync –syncgroup –name <name>

6. While the mirrors are synchronizing or a consistent state, you can add all the LUNs (if you

have not already done so) to the ESX Server CLARiiON Storage Group at the protected and

recovery site using the following command:

naviseccli –h SP ipaddress storagegroup –addhlu –gname <ESX CLARiiON Storage Group

Name> -hlu <Host Device ID> -alu <Array LUN ID>

Configuring async mirrors using NaviSecCLI

The following steps outline the process for setting up asynchronous replication using Navisphere

SecureCLI commands. The commands should be run from a management host that is connected to the

production CLARiiON storage array:

1. If not already established, create a path or paths for remote mirroring between the primary and

secondary CLARiiON with this command:

naviseccli –h SP ipaddress mirror –async –enablepath SPhostname

[-connection type fibre|iscsi]

2. Once you have created mirror paths, create a remote mirror of the LUN(s) that you wish to

protect with SRM. The LUN(s) on which the mirror is created becomes the primary image.

naviseccli –h SP ipaddress mirror –async –create –lun <LUN_Number>

3. The secondary image on the remote CLARiiON can then be added to the primary image.

After the secondary image is added, the initial synchronization between the primary and

secondary images begins. (The following command assumes that the LUN(s) are already

created on the remote CLARiiON storage system).

naviseccli –h SP ipaddress mirror –async –addimage –name <name> -arrayhost

<hostname| sp ip-address> -lun <lunnumber | lunuid>

4. Even if there is only a single LUN being replicated to the secondary site, you still need to

create a consistency group for SRM. The following commands create a consistency group

and add existing mirrors to the consistency group.

naviseccli –h SP ipaddress mirror –async –creategroup –name <name>

naviseccli –h SP ipaddress mirror –async –addgroup –name <name>

EMC CLARiiON Integration with

VMware ESX Server

Applied Technology 45

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 57 58

Sin comentarios

Dell AX4-5 Especificaciones Pagina 45