Dell PowerVault NX1950 Manual de usuario descargar pdf (Pagina 24)

24 Quick Install Steps for Initiator-Target Connection

In the

Log On to Target

window, click

The

Ta rg et s

tab displays the status of the Target as

Connected

To accomplish Multipathing, you can use Microsoft MPIO to establish

multiple sessions from host to the same Target device. To establish

multiple sessions:

Go to the

Ta rg et s

tab and select the Target that is

Connected

Repeat step 1 to step 4.

In the

Advanced Settings

→

Target Portal

address, choose the redundant

host IP address and the IP address of the PowerVault NX1950 storage

solution.

NOTE: During the iSCSI Initiator software installation, Microsoft MPIO is

already selected. MPIO is supported with Initiator version of 2.06 or later. You

require two dedicated iSCSI NICs in the target and initiator for efficient MPIO

connection. Multiple connections per session (MC/S) is not supported on the

PowerVault NX1950 storage solution.

To initialize and configure the iSCSI device as local drive and perform iSCSI

I/O operations, select

Computer Management

→

Disk Management

option.

NOTICE: If you are configuring the host to access multiple targets (VHD files),

ensure that the hosts are clustered. If multiple hosts access the same target, data

corruption may occur. For more information, see "Enabling Multi-Path on the

Initiator" on page 61.

Method 2 (Discovery Using iSNS Server)

This section describes the procedure for iSCSI Target discovery using the

iSNS server. For more information about the iSNS server, see "Appendix" on

page 55.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 69 70

Sin comentarios

Dell PowerVault NX1950 Manual de usuario Pagina 24