Dell PowerVault NX1950 Manual de usuario Pagina 66

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 70
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 65
66 Appendix
To configure the iSNS Server, perform the following steps.
1
Log on to the server where you have installed the iSNS Server 3.0 and go to
Start
Programs
Microsoft iSNS Server
Configure iSNS server
.
The iSNS Server screen consists of three tabs namely—
General
,
Discovery
Domains
, and
Discovery Domain Sets
. The
General
tab lists all devices
(iSCSI Initiators and Targets) that are registered with the iSNS Server.
Perform the following procedure to add Targets and Initiators to the
iSNS Server:
a
Go to the
iSCSI Initiator properties
Discovery
iSNS Servers
Add
and add the IP address or DNS name of the Initiator and register this
Initiator to the iSNS server.
b
Log in to the iSNS server and go to
Start
Programs
Microsoft iSNS
Server
Configure iSNS server
General
tab. The Initiator that you
registered with iSNS Server in step a is listed. Similarly all iSCSI
Initiators that you register with iSNS Server are listed in the
General
tab.
c
Log in to the PowerVault NX1950 storage solution that you configured
as a Target and go to
PowerVault NX1950 Management Console
Microsoft iSCSI Software Target
right-click and select
Properties
iSNS
tab and add iSNS server IP address or DNS name.
d
To verify, log in to the iSNS Server and check the
General
tab to ensure
that all Targets of PowerVault NX1950 storage solution are listed.
If multiple PowerVault NX1950 storage systems are registered with iSNS
server, then all Target Devices that are created in the PowerVault NX1950
storage systems are listed in iSNS server.
2
You can use the
Discovery Domains
feature to group certain Initiators
with Targets with specific access:
a
Go to
iSNS Server Properties
Discovery Domains
tab
click
Create
enter a name for the Discovery domain
select
Add
.
b
The
Add registered Initiator or Target to Discovery Domain
screen
appears. Select the specific Initiators and Targets that you want to
configure and click
OK
.
3
You can configure multiple Discovery Domains in the iSCSI network.
The domains are listed in the
Discovery Domain Sets
tab. The
Discovery
Domain Sets
tab displays Default DD and Default DDS options. You can
create any number of groups as required.
Vista de pagina 65
1 2 ... 61 62 63 64 65 66 67 68 69 70

Comentarios a estos manuales

Sin comentarios