Error Code Message Information
Action Reinstall the SD module.
RFM2004
Message Failure detected on Internal Dual SD Module <
name
>.
LCD Message Internal Dual SD Module <
name
> failed. Check SD Card.
Details The SD card module is installed but improperly configured or failed to initialize.
Action Reinstall the SD module and remove and reinstall SD cards.
RFM2006
Message Internal Dual SD Module <
name
> is write protected.
Details The module is write-protected. Changes may not be written to the media.
Action If unintended, remove the media and disable write protection.
SEC0031
Message The chassis is open while the power is on.
LCD Message Intrusion detected. Check chassis cover.
Details The chassis is open. System performance may be degraded, and security may be
compromised.
Action Close the chassis. Check system logs.
SEC0033
Message The chassis is open while the power is off.
LCD Message Intrusion detected. Check chassis cover.
Details The chassis was opened while the power was off. System security may have been
compromised.
Action Close the chassis and verify hardware inventory. Check system logs.
SEL0006
Message All event logging is disabled.
Details This message is displayed when all event logging has been disabled by the user.
Action If unintended, re-enable logging.
SEL0008
Message Log is full.
Details When the event log is full, additional events are not written to the log. Older events may be
overwritten and lost. This message may also appear if the user disabled event logging.
Action Backup and clear log.
SEL0012
Message Could not create or initialize the system event log.
Details If the system event log fails to initialize, platform status and failure events are not captured.
Some management software do not report platform exceptions.
Action Reboot the management controller or iDRAC. Cycle system input power. If problem persists
call support.
129
Comentarios a estos manuales