Dell PowerVault NX3200 Manual de usuario descargar pdf (Pagina 54)

Figure 21. Removing and Installing the Cable Retention Bracket

1. alignment pins (2)

2. tab

3. cable retention bracket

Installing The Cable Retention Bracket

CAUTION: Many repairs may only be done by a certified service technician. You should only perform

troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or

telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your

warranty. Read and follow the safety instructions that came with the product.

1. Turn off the system, including any attached peripherals, and disconnect the system from its electrical outlet.

2. Open the system.

3. Using alignment pins as guide, slide the cable retention bracket along the chassis wall until the tab snaps into

place.

4. Place all cables to be routed in the cable retention bracket.

5. Install the cooling shroud.

6. Close the system.

7. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Expansion Cards And Expansion-Card Risers

NOTE: A missing or an unsupported expansion-card riser logs an SEL event. It does not prevent your system from

powering on and no BIOS POST message or F1/F2 pause is displayed.

Expansion Card Installation Guidelines

Your system supports six expansion cards.

The following PCI Express Generation 3 expansion cards are supported:

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 132 133

Sin comentarios

Dell PowerVault NX3200 Manual de usuario Pagina 54