Dell 3-DNS Especificaciones descargar pdf (Pagina 39)

Using the Setup Utility

BIG-IP® Reference Guide 2-1

Creating the initial software configuration with the Setup

utility

Once you install and connect the hardware, the next step in the installation

process is to turn the system on and run the Setup utility. The Setup utility

defines the initial configuration settings required to install the BIG-IP into

the network. You can run the Setup utility remotely from a web browser, or

from an SSH or Telnet client, or you can run it directly from the console.

Before you connect to the unit, we recommend that you gather the list of

information outlined in the configuration worksheet provided with the

BIG-IP. Note that the screens you see are tailored to the specific hardware

and software configuration that you have. For example, if you have a

stand-alone system, the Setup utility prompts you to skip the redundant

system screens.

Once you have configured the base network elements with the Setup utility,

you might want to further enhance the configuration of these elements. For

additional information about these configuration tasks, see Chapter 3,

Additional Base Network Configuration.

Connecting to the BIG-IP for the first time

The Setup utility prompts you to enter the same information, whether you

run the utility from a web browser, or from the command line. When the

utility completes we recommend that you reboot the unit. This automatically

removes the default IP address and root password provided specifically for

the purposes of running the Setup utility remotely. The BIG-IP replaces the

default IP address and root password with the password and IP addresses

that you define while running the utility.

Running the utility from the console or serial terminal

Before you can run the Setup utility from either the console or a serial

terminal, you must first log in. Use the following default user name and

password to log in.

Username: root

Password: default

After you log in, you can start the utility directly from the console or serial

terminal by typing the command config. Once you complete the utility, we

recommend that you reboot the BIG-IP. The BIG-IP automatically reboots if

you are running the utility for the first time from the console.

Note

If you want to set up a terminal connection directly to the BIG-IP, see Using

a serial terminal with the BIG-IP, on page 12-11.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 425 426

Sin comentarios

Dell 3-DNS Especificaciones Pagina 39