Dell 3-DNS Especificaciones descargar pdf (Pagina 58)

100

101

Chapter 3

3-4

Use the following syntax to display the current status and the setting for a

specific interface.

b interface <if_name> show

Media type and duplex mode

Properties that are configurable on the interfaces include media type and

duplex mode, as shown in Table 3.1.

Setting the media type

You can set the media type to the specific media type for the interface card

or to auto for auto detection. If the media type is set to auto and the card

does not support auto detection, the default type for that interface is used,

for example 1000BaseTX.

Use the following syntax to set the media type:

b interface <if_name> media <media_type> | auto

(Default media type is auto.)

Note

If the BIG-IP is inter-operating with an external switch, the media setting

should match that of the switch. For more information, see Setting the

interface media type, on page 2-6.

Setting the duplex mode

You can set duplex mode to full or half duplex. If the media type does not

allow duplex mode to be set, this is indicated by an onscreen message. If

media type is set to auto, or if setting duplex mode is not supported for the

interface, the duplex setting is not saved to bigip_base.conf.

Use the following syntax to set the duplex mode:

b interface <if_name> duplex full | half | auto

(Default mode is auto.)

Interface Properties Description

media You may specify a media type or use auto for automatic

detection.

duplex You may specify a full or half duplex mode, or use auto for

automatic selection.

Table 3.1 The attributes you can configure for an interface

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 425 426

Comentarios a estos manuales

Sin comentarios

Dell 3-DNS Especificaciones Pagina 58

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Dell 3-DNS