Dell PowerEdge 1800 Guía para resolver problemas descargar pdf (Pagina 100)

100 Installing Drives

www.dell.com | support.dell.com

NOTICE: Cables not installed into the drive-cable retainer may block air flow and cause the system to

overheat.

Slide the interface cable into the drive-cable retainer.

Replace the hard-drive bay and screws.

Replace the expansion-card guide.

Replace the baffle/back fan assembly. See "Installing the Baffle/Back Fan Assembly."

Figure 7-4. Accessing the System Board Drive Connectors

Connect the interface cable to the drive and to the system board or controller card.

• Figure 7-5

illustrates a common cable configuration for externally accessible IDE drives.

• Figure 7-6 illustrates a SCSI half-height tape drive connected to the SCSI controller on

the system board.

• Figure 7-7 shows a SCSI half-height tape drive connected to a SCSI controller card.

For information about the controller card, see the documentation that accompanied the

card.

drive bay

drive-cable

retainer

interface cable

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 159 160

Sin comentarios

Dell PowerEdge 1800 Guía para resolver problemas Pagina 100