
Installing Drives 95
Figure 7-1. Removing a Diskette Drive
Installing a Diskette Drive
CAUTION: Before you perform this procedure, see "Safety First—For You and Your System" in
"Troubleshooting Your System."
CAUTION: See "Protecting Against Electrostatic Discharge" in the safety instructions in your Product
Information Guide.
1
Connect the power cable and the interface cable to the diskette drive.
2
Slide the diskette drive into the externally accessible drive bay. See Figure 7-1.
3
If your system is configured as a tower, stand the system upright.
4
Close the system. See "Closing the System" in "Troubleshooting Your System".
5
Reconnect the system to its electrical outlet and turn the system on, including any attached
peripherals.
diskette drive
tabs (2)
power cable
interface cable
Comentarios a estos manuales