l Error message indicates a problem with the optional diskette drive.
Action
1. Enter the System Setup program and verify that the diskette controller is enabled and the diskette drive is configured correctly. See "Using the System
Setup Program" in the User's Guide.
2. Run the appropriate online diagnostic test. See "Using Server Administrator Diagnostics" in "Running System Diagnostics."
3. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
4. Ensure that the diskette/optical drive carrier is fully inserted in the system chassis. See Figure7-3.
5. Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
6. Run the appropriate online diagnostic test to see whether the diskette drive works correctly.
7. Turn off the system and attached peripherals, and disconnect the system from its electrical outlet.
8. Open the system. See "Opening the System."
9. Remove all expansion cards installed in the system. See "Removing an Expansion Card" in "Installing System Components."
10. Close the system. See "Closing the System."
11. Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
12. Run the appropriate online diagnostic test to see whether the diskette drive works correctly.
If the tests run successfully, an expansion card may be conflicting with the diskette drive logic, or an expansion card may be faulty. Continue to the next
step.
If the tests fail, see "Getting Help."
13. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
14. Open the system. See "Opening the System."
15. Reinstall one of the expansion cards you removed in step 9. See "Installing an Expansion Card" in "Installing System Components."
16. Close the system. See "Closing the System."
17. Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
18. Run the appropriate online diagnostic test to see whether the diskette drive works correctly.
19. Repeat step 13 through step 18 until all expansion cards are reinstalled or one of the expansion cards causes the tests to fail.
If the problem is not resolved, see "Getting Help."
Troubleshooting an Optical Drive
Problem
l System cannot read data from a CD.
l Optical drive indicator does not blink during boot.
Action
Comentarios a estos manuales