If two SCSI cables are connected, note their relative locations.
4. Unlock the expansion-card cage cam lever and rotate it to the vertical position. See Figure6-12.
5. Lift the expansion-card cage from the chassis.
Figure 6-12. Installing and Removing the Expansion-Card Cage
Installing the Expansion-Card Cage
1. Reinstall any expansion card(s). See "Installing an Expansion Card."
2. Raise the expansion-card cage cam lever to a vertical position. See Figure6-12.
3. Fit the guide rail on the back of the expansion-card cage into the corresponding notch in the system chassis, then lower the expansion-card cage into
the system chassis. See Figure6-12.
4. As you lower the cage into place, the two alignment pins fit into the slots in the side of the system.
5. Carefully close the cam lever to lock the card cage into place.
6. Reconnect the SCSI data cable(s) to the SCSI connector(s) on the riser card or SCSI controller. SeeFigureA-4.
7. Close the system. See "Closing the System" in "Troubleshooting Your System."
Installing an Expansion Card
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See
your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against
electrostatic discharge.
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See
your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against
electrostatic discharge.
Comentarios a estos manuales