
Installing System Components 59
Removing a Hard Drive From a Hard-Drive Carrier
CAUTION: Use only hard drives that have been tested and approved for use with
the SAS/SATA backplane.
CAUTION: When installing a hard drive, ensure that the adjacent drives are fully
installed. Inserting a hard-drive carrier and attempting to lock its handle next to a
partially installed carrier can damage the partially installed carrier's shield spring
and make it unusable.
Remove the screws from the slide rails on the hard-drive carrier and separate
the hard drive from the carrier. See Figure 2-6.
Figure 2-6. Removing and Installing a Hard Drive
1 screws (4) 2 hard drive
3 SAS/SATA screw hole 4 hard-drive carrier
book.book Page 59 Monday, January 24, 2011 12:24 PM
Comentarios a estos manuales