Dell EMC AX4-5 Guía de instalación descargar pdf (Pagina 29)

29

Fixed problems

EMC AX4-5 Series Integrated Management Software Release Notes

Platforms Brief description Symptom details

Solution (or

workaround)

AX4-5

AX4-5i

AX4-5SC

AX4-5SCi

FLARE Operating

Environment

A Navisphere Express alert is

not cleared after an SPS

misconfiguration is corrected.

184205

Frequency of occurrence

:

Always under a specific set of

circumstances.

Severity

:

Low

After correcting an SPS

cabling misconfiguration,

the Navisphere Express

alert persists until the next

time the SPS is tested.

Navisphere Express

now shows the proper

state of the SPS

configuration.

Exists in version

:

02.23.050.5.004

Fixed in version:

02.23.050.5.504

AX4-5

AX4-5i

AX4-5SC

AX4-5SCi

FLARE Operating

Environment

When a disk fails and is in the

process of rebuilding to a hot

spare, if the original (failed) disk

is replaced and starts to power

up, it will remain in a powerup

state until the rebuild to the hot

spare completes.

184167

Frequency of occurrence

:

Always

Severity:

Medium

When a disk fails and is in

the process of rebuilding to

a hot spare, if the original

(failed) disk is replaced

and starts to power up, it

will remain in a powerup

state until the rebuild to the

hot spare completes.

The equalize will begin

from the hot spare to the

replaced disk as soon as

the rebuild is complete,

and the hot spare swap-

out will occur as expected.

Re-inserting a failed

drive while the RAID

group is rebuilding to

the hot spare will now

result in immediate

swap-out of the hot

spare.

Exists in version

:

02.23.050.5.004

Fixed in version

:

02.23.050.5.504

AX4-5

AX4-5i

AX4-5SC

AX4-5SCi

FLARE Operating

Environment

The software indicates a drive

failure when there is a single

connection failure between an

LCC and a drive, even if the

LCC is the faulted component.

182470

Frequency of occurrence

:

Rarely under a specific set of

circumstances

Severity

:

Medium

The Navisphere user

interface incorrectly

indicates a drive failure

when a single connection

failure between an LCC

and a drive occurs. It is

possible that the actual

faulted component is the

LCC and replacing the

drive does not clear the

alert. This problem is

limited to the first failure

within a RAID group.

The user interface now

properly differentiates

between drive and

LCC failures.

Exists in version

:

02.23.050.5.004

Fixed in version

:

02.23.050.5.504

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 46 47

Comentarios a estos manuales

Sin comentarios