Dell EMC AX4-5 Guía de instalación descargar pdf (Pagina 39)

Technical notes

EMC AX4-5 Series Integrated Management Software Release Notes

Technical notes

This section contains information that will help with the installation, use,

and management of the storage system. It provides generic information

that applies to all platforms, as well as platform-specific information.

Navisphere CLI

Navisphere CLI is no longer supported on the AX4-5 series storage

systems. Navisphere Secure CLI should be used instead.

Background verify

To improve system performance, the default rate for background verify

operations has been changed from ASAP to Medium. For systems

running 02.23.050.5.004 which are upgraded to 02.23.050.5.504 or

02.23.050.5.7xx, the rate will remain at Medium unless manually changed

using Navisphere Manager (requires full Navisphere Manager to be

installed).

Single-SP configuration

The proper configuration for single-SP systems has the SP installed in the

SP A slot of the DPE. A single-SP storage system with the SP installed in

the B slot causes continuous reboot of the SP.

Single-SP to dual-SP upgrades

1. Install the Dual-SP enabler using Navisphere Express and wait for

installation to complete. Verify using NaviSecCli ndu -status.

2. Destroy domain and security information using the Setup page

option.

3. Install SP B (with the storage system powered up).

4. Wait for SP B to boot and stabilize. The SP fault LED will become

solid green.

5. Use the Navisphere Initialization Tool UI to discover the storage

system. Repeat until both SPs are displayed when next is clicked.

6. Use the Initialization Tool UI to set up the storage system.

7. Wait for both SPs to reboot (to pick up new IP information)

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 45 46 47

Sin comentarios

Dell EMC AX4-5 Guía de instalación Pagina 39