Dell Data Protection | Encryption Manual de instalación Pagina 19

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 102
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 18
Installation Guide 19
4
Installation Tasks
To install and activate Personal Edition, you must be a
local or domain Admin
user.
If upgrading, Dell recommends upgrading when no encryption sweep is running. Performing an upgrade during an
encryption
sweep may prevent the client from restarting normally after the installation finishes. If this occurs, a
computer restart corrects the issue.
If running Windows 8.1 and installing Security Tools, you will be securing access to this computer using advanced
authentication cr
edentials that are managed and enrolled using Dell Data Protection | Security Tools. DDP|ST is now
the primary manager of your authentication credentials for Windows Sign-in, including Windows password, fingerprints,
and smart cards. Picture password, PIN, and fingerprint credentials enrolled using the Microsoft Operating System will
not be recognized at Windows Sign-in.
To continue using the Microsoft Operating System to manage your credentials, uninstall DDP|ST.
Dell recommends that you do not change the authentication method afte
r HCA policy has been set to True. If you must
switch to a different authentication method, you must either:
Remove all the users from the PBA,
and then re-enroll the users.
or
Set the HCA policy to False, change
the authentication method, and then reset the HCA policy to True.
To use smart cards with Windows authentication, the following
registry value must be set on the client computer:
Once the client is installed
, create the following Windows Registry entry on the computer targeted for smart card usage.
1
Click
All Programs > Run
from the Windows Start menu.
2
Enter
regedit
in the Open: field.
3
Go to
HKLM\SOFTWARE\DigitalPersona\Policies\Default\SmartCards
.
4
Right-click in the right pane and select
New > DWORD Value
.
5
Name the key
MSSmartcardSupport
.
6
Double-click the key to open it.
7
Enter
1
in the Value Data: field.
8
Select
Hexadecimal
in the Base section.
9
Click
OK
to save and close the key.
10
Close the Registry Editor.
NOTE: Smart card usage with PBA is not supported in Personal Edition.
Vista de pagina 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 101 102

Comentarios a estos manuales

Sin comentarios