Dell Chassis Management Controller Version 4.50 Manual de usuario descargar pdf (Pagina 231)

NOTE: Make sure that the CMC module becomes the active CMC, and remains the active CMC until the

remaining steps are completed.

4. If the jumpered CMC module is the only CMC, then wait for it to finish rebooting. If there is a redundant CMCs in the

chassis, then initiate a changeover to make the jumpered CMC module active. In the Web interface, in the system

tree, go to

Chassis Overview and click Power → Control, select the Reset CMC (warm boot), and click Apply.

CMC automatically fails over to the redundant module, and that module now becomes active.

5. Log into the active CMC using the default administrator username:root and password: calvin, and restore any

necessary user account settings. The existing accounts and passwords are not disabled and are still active.

6. Perform the required management actions, including creating a new administrator password.

7. Remove the 2-pin PASSWORD_RST jumper and replace the jumper plug.

a) Press in the CMC release latch on the handle and move the handle away from the module front panel. Slide the

CMC module out of the enclosure.

b) Remove the 2-pin jumper and replace the jumper plug.

c) Slide the CMC module into the enclosure. Reattach any cables that were disconnected. Repeat step 4 to make

the unjumpered CMC module the active CMC.

231

1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 259 260

Sin comentarios

Dell Chassis Management Controller Version 4.50 Manual de usuario Pagina 231