Dell Vizioncore Guía de usuario descargar pdf (Pagina 68)

vReplicator v2.5 Chapter 3 Configuration 65

Default Start Up

Connection

When vReplicator boots, it will automatically attempt to

connect to any configured VCs or hosts. vReplicator can only

connect to one at a time—VCs or hosts—not to both

simultaneously. This field indicates the default host to which

vReplicator will connect.

You will know that the host default has been set if this

message displays below the field: Load Host(s) on start up.

Configured Host List

(text box)

Each host that has been configured in this instance of

vReplicator is listed in this text box.

Add New Host When you click this button, the Add Host dialog displays.

From this dialog, you can add a host.

Remove Host When you click this button, you can remove any host that

displays in the Configured Host List.

Set As Default Sets the Default Start Up Connection to the selected host.

Connect to Hosts Click this button to connect to any host that displays in the

Configured Host List. If vReplicator is connected to a VC

when you click this button, the VC connection will be closed

before vReplicator connects to the host.

Enable vzBoost

(checkmark button)

Select this checkmark button to improve write speeds to

VMFS. When you enable vzBoost, a driver is installed on the

ESX host. This driver is only active during a vReplicator

write and can be removed without rebooting the server.

What is vzBoost?

(link)

Click this link to access a window that contains a general

definition of vzBoost.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 188 189

Sin comentarios

Dell Vizioncore Guía de usuario Pagina 68