Dell Active Fabric Manager Guía de usuario Pagina 142

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 179
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 141
REDEPLOYMENT REQUIRED Re-deployment of the switch
is required
Yes Restart the deployment of the switch.
NOTE: The switch is not in BMP
mode.
1. Navigate to the Network >
Fabric
Name
> Configure and Deploy
screen.
2. From the Deploy Fabric pull-down
menu, select the Deploy and
Validate option.
3. On the Deploy tab, check the
switch to deploy and then click
the Deploy Selected link.
Use the following table to diagnose AFM deployment tasks that have failed.
Table 38. AFM Deployment Tasks
AFM Deployment
Task
Error Status Recommended Action
Verify switch
eligibility
Eligibility check for
deployment: Failed
VLT switch deployment needs management ip for all its peers
Ping verification Ping verification: Failed Verify DHCP offer is received in the device console; Power cycle if
needed
Telnet/SSH
connectivity
verification
Telnet/SSH session
verification: Failed
Verify Telnet/SSH connection; Verify DHCP offer is received in the
device console; Power cycle if needed
Reset to factory
defaults
Reset to factory defaults
task: Failed
Verify Telnet/SSH connectivity and deploy again
Minimal
configuration
upload to switch
Minimal config upload:
Failed
Verify Telnet/SSH connectivity and deploy again
Minimal config upload on
Unit-1: Failed
Verify Telnet/SSH connectivity and deploy again
Reload of switch Reboot of switch: Failed Verify Telnet/SSH connectivity and deploy again
Boot image error Boot image was not loaded
from flash
Change the boot image path to flash by executing the CLI command
through console session.
Stack unit cleanup Stack unit renumbering
task: Failed
Verify Telnet/SSH/SNMP connectivity
Upgrade standby Upgrade standby: Failed Standby MAC not found or reported card problem, verify standby
switch
Full configuration
file transfer
Full config file transfer to
TFTP/FTP server: Failed
Verify the TFTP/FTP connectivity. Verify FTP credentials
TFTP/FTP
connectivity
TFTP/FTP connection issue
between switch and TFTP
server
Verify TFTP/FTP connectivity between the switch and TFTP server
Full configuration
upload to switch
Full config upload: Failed Verify TFTP/FTP and Telnet/SSH connectivity and deploy again.Or
Verify optional modules have been installed per fabric design.
Verify whether AFM supported software version is used.
142
Vista de pagina 141
1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 178 179

Comentarios a estos manuales

Sin comentarios