Dell Active Fabric Manager Guía de usuario descargar pdf (Pagina 159)

NOTE:

You must replace the switch with the same type of switch. See Replacing a Switch.

To decommission a switch:

1. Navigate to the Network >

Fabric Name

Switch Name

2. Click the Switch Replacement tab.

The Switch Replacement Summary screen displays.

3. Click the Decommission Switch link.

The Decommission Switch screen is displayed.

4. Review and follow the instructions on the Decommission screen.

5. Click the Save button to save the text file that contains information to submit a Return Material Authorization (RMA).

Send this information to your Dell Networking software support representative to arrange switch replacement at

the iSupport Portal at http://www.force10networks.com/support/.

6. Once a replacement switch is available, click the Replace Switch link.

Step 2: Replacing a Switch

Pre-requisites

Before you replace a switch, gather the following useful information:

• Obtain the system MAC address, service tag and serial number for the new switch to be used for replacement,

provided from Dell.

• Location of the switch, including the rack and row number from your network administrator or operator.

• Remote Trivial File Transfer Protocol (TFTP) / File Transfer Protocol (FTP) address from your network administrator or

operation.

• Last deployed FTOS Software Image for switch being replaced should be on the TFTP/FTP site. The software images

on the TFTP/FTP site is used by the switch to install the appropriate FTOS software image and configuration file.

• Dynamic Host Configuration Protocol (DHCP) server configuration will need update. If remote DHCP server is used

then you need to manually update the same based on configuration provided by AFM. If local DHCP server is used,

AFM will update the DHCP server automatically. After you power cycle the switches, the switches communicate

with the DHCP server to obtain an management IP Address based on the system MAC Address. The DHCP server

contains information about where to load the correct software image configuration file for each type of switch from

the TFTP/FTP site during bare metal provisioning (BMP).

To replace a switch:

1. Navigate to the Network >

Fabric Name

Switch Name

screen.

2. Click the Switch Replacement tab and then click the Replace Switch link.

3. Review the introduction and instructions on the Switch Cabling screen.

4. Confirm that the replacement switch is racked, cabled, and powered on. If this is not the case, use the following

wiring diagram to cable the replacement switch.

5. Click the Next button.

The MAC Replacement screen displays.

6. In the MAC Replacement screen, enter the following information for the replacement switch:

a) The new serial number in the New Serial Number field.

b) The new service tag in the New Service Tag field.

c) The new system MAC address for the replacement switch in the New MAC address field.

159

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 178 179

Comentarios a estos manuales

Sin comentarios

Dell Active Fabric Manager Guía de usuario Pagina 159

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Dell Active Fabric Manager